Here is my USB PIC programmer.It is actually a clone of Pickit2 programmer. The PCB has been done with Cadsoft Eagle Professional 5.10.0. I have attached the actual PCB layout in PDF format.The firmware for the PIC 18F2550 is also available there.You need to program this PIC 18F2550 from a different programmer & make it permanent inside this programmer.
The USB PIC programmer consists with a standard 5 pin header to connect an external target board.
Target pins = PGC,PGD,GND,VDD,MCLR
Use an appropriate external target board pins to this header.Then you can place new PIC micro controllers to the target board & program those PICs.
Here is the PCB.
https://drive.google.com/file/d/0B3RELHoBhPvpa1hoTUZneEdTOXM/view?usp=sharing
PIC18F2550 Firmware
https://drive.google.com/file/d/0B3RELHoBhPvpeVRmX0ZSVXctcnM/view?usp=sharing
PICkit2 software can be downloaded from MICROCHIP website from below link.
Here is the PCB.
https://drive.google.com/file/d/0B3RELHoBhPvpa1hoTUZneEdTOXM/view?usp=sharing
PIC18F2550 Firmware
https://drive.google.com/file/d/0B3RELHoBhPvpeVRmX0ZSVXctcnM/view?usp=sharing
PICkit2 software can be downloaded from MICROCHIP website from below link.
Download "PICkit 2 V2.61 Install with .NET Framework A"
http://www.microchip.com/DevelopmentTools/ProductDetails.aspx?PartNO=pg164120
http://www.microchip.com/DevelopmentTools/ProductDetails.aspx?PartNO=pg164120
Hello, my name is Jack Sparrow. I'm a 50 year old self-employed Pirate from the Caribbean.
No comments:
Post a Comment